How To Finish Butcher Block For Desk

How To Finish Butcher Block For Desk

How To Finish Butcher Block For Desk. He also used a few screws and attached the butcher block to. Cut out for any structures in the way if wall mounting.

How To Finish Butcher Block For DeskHow To Finish Butcher Block For Desk
Countertop Epoxy Butcher Block Is Countertop Epoxy Butcher Block Any from www.pinterest.com.au

Allow to dry over 24 hours. Lay down a few strips of painter’s tape to avoid marks left by the base plate of the saw or any other tools you may use. Next up, because i wanted a butcher block look to my desk, i went in an marked and taped up (again to avoid tear out) a bunch of additional areas that i wanted to cut further.

Just Did This For My Setup.

Then apply a second coat again on all surfaces. Apply next coat if desired, etc. You need to put on the first coat of water polyurethane on all surfaces with a foam brush not just the top and sides.when it has completely dried lightly sand it with higher grit sand paper.

Use A Track Saw, Or Similar To Break Down Your Standard Butcher Block Counter Top Into Main Desk Top, And Any Legs (As Required).

It will darken the wood a bit. Repeat two or three times before you use it, and whenever the wood dulls. All you need to do is pour on a good puddle of the chosen oil, spread it around with a clean cloth or gauze.

Then It Was Time To Cut Some Butcher Block!

Next up, because i wanted a butcher block look to my desk, i went in an marked and taped up (again to avoid tear out) a bunch of additional areas that i wanted to cut further. See the “ cutting your butcher block ” tutorial for more information. After an exhaustive search, i sourced this rubberwood butcher block from lowe’s and purchased one 8′ two 6′ slabs.

Read  Best Online Games Unblocked

The Triangular Leg Shown In The Main Picture Gives Plenty Of Joint Surface For A Good Attachment, But Go With What You Prefer.

Oil based stain with a thick gel like consistency helps enhance the beauty of the wood. To finish a custom kitchen desk made from kitchen cabinets that were cut down i needed to stain and finish the butcher block top. The desk leg was then screwed into the wall (through the stud along the floor).

Mineral Oil And Walnut Oil.

You will need 1 quart polyurethane to seal 300 square feet of countertop with 3 coats. Materials and tools to seal butcher block countertop. Sand and remove everything until you have a smooth finish.