How To Light Pilot Light On Ventless Gas Fireplace References

How To Light Pilot Light On Ventless Gas Fireplace References

How To Light Pilot Light On Ventless Gas Fireplace References. The pilot, found as part of the ignition, can often be seen when looking down from above within the firebox or below through the control area. This allows the gas to reach the pilot assembly.

How To Light Pilot Light On Ventless Gas Fireplace ReferencesHow To Light Pilot Light On Ventless Gas Fireplace References
How To Light Pilot Light On Ventless Gas Fireplace References . nucast 2022 from www.nucast.us

Release knob if pilot stays lit (if not, go back to step 3 and repeat). This continuous flame is necessary to light large burners such as those found in gas fireplaces. Twist the shutoff valve to make it bring it parallel to the gas line.

Content post

Turn Control Knob Counterclockwise To The On.

Trying to light the pilot on a valor g4 fireplace. The pilot, found as part of the ignition, can often be seen when looking down from above within the firebox or below through the control area. Ensure the control knob is at the lowest flame setting.

You Will Need To Hold Your Pilot Button For The Allotted Time That Your Owner’s Manual Suggests.

You turn the control knob to the pilot position, push the knob in, light the pilot with a match, then hold the knob down for 30 seconds or so until the pilot stays lit by itself. Locate the switch, which should be marked ‘on.’. Read the user’s guide carefully.

After Lighting Gas Logs Pilot Light, Set The Handle To The “On” Position.

Rotate it to the left and push it in, allowing gas to flow to the pilot light. The pilot light in a gas fireplace is typically found adjacent to the main burner, below the fireplace media such as logs or coals. Locate the control panel on the fireplace and open it.

Turn The Control Knob To A Pilot Position.

This allows the gas to reach the pilot assembly. Twist the shutoff valve to make it bring it parallel to the gas line. Release the knob and let the flame burn for about 60 seconds.

Push In Knob (This Releases The Gas To The Pilot Area Only).

Turn off the control knob for about 5 minutes. Release knob if pilot stays lit (if not, go back to step 3 and repeat). This allows the gas to reach the pilot assembly.

Read  Review Of Cricut Explore Air 2 Software Free Download References